Pulse Amplifier/Puff Valve Driver – Zerif Technologies Ltd.

Pulse Amplifier | Up to 800 V | 4 Independent Channels | Rapidly actuate valves, hold open

The EHT Pulse Amplifier offers a simple way to generate high voltage pulses up to 800 V. This unit includes four independently triggered channels and features a dual voltage isolated internal supply that can rapidly actuate valves, and then hold them open continuously. The user can choose whether to connect an external higher power voltage source up to 800 V, or can elect to use the internal power supplies. This module is controllable via fiber or BNC input, at frequencies up to 50 kHz.

Features

Specifications

Eagle Harbor Technologies Pulse Amplifier Puff Valve Driver Circuit Block Diagram showing three ways user-selected voltage sources for 4 output channels.
Pulse Amplifier/Puff Valve Driver Circuit Block Diagram: three user-selected voltage sources. 

Puff Valve Driving

The EHT Pulse Amplifier can drive four independent miniature high speed, high vacuum pulse valves at higher actuation speeds than is possible using the working voltage level of the valves. It works by quickly energizing the valve with 250 V (labeled 300 V on front panel) for a short time of < 500 µs before providing an even 18 V “keep alive” voltage that holds the valve open at low power.

The Pulse Amplifier can operate any combination of pulse valves independently but the maximum repetition rate is halved for each additional valve driven simultaneously, i.e. 20 Hz for one valve, 10 Hz for two, 5 Hz for three, and 2.5 Hz for four actuated valves. It is possible to drive the valves faster than the advertised maximum without harm to the valves or the unit, but the valve opening characteristic may change depending on available charge on internal energy storage capacitors.

The following figures were determined with a Parker 28 V 70 Ω pulse valve load.

Min pulse width figure is gathered from Parker pulse valve datasheet. It is possible to partially open the valve with much smaller pulse time.

Eagle Harbor Technologies Pulse Amplifier Puff Valve Driver supports 10 A per 4x channel with bursts to 40 A and Frequency up to 250 Hz.
Pulse Amplifier/Puff Valve Driver with 10 A per 4x channel, with bursts to 40 A. 
Eagle Harbor Technologies Puff Valve Driver driving two valves at 10 Hz repetition Waveform shows the internal energy storage capacitors voltage reaches maximum voltage between shots, the output current, and the output voltage.
Puff Valve Driver Waveform: Pulse Amplifier driving two valves at 10 Hz repetition. The figure shows the internal energy storage capacitors voltage (yellow) reaches maximum voltage between shots, the output current (green), and the output voltage (blue).